Gocycle
®
Owner’s Manual for G2, August 2015
© Karbon Kinetics Limited. All Rights Reserved. 53
WARNING! Should you discover a fatigue crack more than 3mm long, or should you suspect that a
component may have received an impact in an unusual way—such as if the product has been
dropped—do not ride your Gocycle and immediately contact techsupport@gocycle.com.
7.6
Adjusting the Shifting
From time to time, it might be necessary to adjust your shifting; for example, if you hear a noise from
your rear hub or your Gocycle is not holding in gear. Your Gocycle’s electronic shifting is calibrated
during production, but you can recalibrate it by adjusting the servo electronically as follows:
Once in mode 15, the display will
show the gear selection and
calibration either side of the
factory default
Keeping the pedals still, select the
gear that you are aiming to adjust
with the gear select button B
Now take your Gocycle for a
ride—whilst pedalling, adjust the
gearing by pressing buttons A or
B as necessary until the gear
remains in place, with no noise
from the rear hub
Press button A to move the servo
position towards the lower gear
Press button B to move the servo
position towards the higher gear
When a gear is properly adjusted
and you are confident that you
have successfully calibrated the
gear, stop pedalling
If there is no further calibration
necessary, go to the last step
If it is necessary to recalibrate
other gears, repeat from the
beginning
To Next Page
Loading...
