Gocycle G2 - Page 73

Gocycle
®
Owner’s Manual for G2, August 2015
© Karbon Kinetics Limited. All Rights Reserved. 70
Periodically remove the front
wheel to check for hub wear
Pay particular attention to the
area indicated
To minimise the potential for hub wear:
 Thoroughly clean and dry your Gocycle after every ride. See 7.3 Cleaning and Preventing
Corrosion for more information.
 Correctly adjust your PitstopWheel cam levers. Check from time to time that their torque is
within the guidelines stated in this manual and that all three on each wheel open and close
with equal pressure.
 From time to time, consider moving the rear PitstopWheel to the front and vice-versa.
Typically, in normal usage, the rear of a Gocycle will carry more load than the front, thus
subjecting the rear hub, wheel and tyre to greater stresses. Periodically swapping the front and
rear PitstopWheels will distribute wear more evenly. Note: When swapping the PitstopWheel,
ensure that the tyre pressures remain within the guidelines stated in this manual. See 7.9 Tyres
for more information.