Gocycle G3 - Page 26

Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 22
1.3. Apply pressure onto the
right hand side of the Snap Rail
Tool Holder (B) until this side is
properly located onto the right
saddle rail.
1.4. Apply pressure onto the left
hand side of the Snap Rail Tool
Holder (B) until this side is
properly located onto the left
saddle rail.
1.5. Confirm both sides of the
Snap Rail Tool Holder (B) are
properly located onto the saddle
rails.