Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 88
8 TROUBLESHOOTING
8.1
Service and Inspection Reminder
Symptom: All battery LEDs and all speed LEDs are flashing alternately.
Resolution: This is a reminder that a service or inspection is due. Please consult section 7.
NOTE: After 100 miles/160 kms and every further 500 miles/800 kms, the dash will alternatively flash
all battery leds “C” and all speed leds “E”. This is an important safety reminder that a service or
inspection is due. In the event that your dash is flashing the service reminder, please visit
www.gocycle.com/safety and review any important Technical Bulletins and safety information relating
to your Gocycle model. You should also download and review the latest Owner’s Manual from
www.gocycle.com/manuals. After visiting www.gocycle.com/safety you can hold selector A and
selector B simultaneously rotated wrist down for 3 seconds to return the dash to normal display.
Note, by resetting the service reminder you are confirming that you have visited
www.gocycle.com/safety and have understood any Technical Bulletins or new information relating to
your Gocycle and you have downloaded and reviewed the Owner’s Manual relating to your Gocycle.
8.2
Unknown Gear State: Gears Will Not Shift
Symptom: No gear shift LEDs are visible on the dashboard display and it is not possible to shift
between gears. The gears remain in the last selected gear.
Resolution: To return to normal shifting, stop riding and remain stationary for up to 5 seconds with
both brakes applied. The Gocycle will reset to first gear and the gear shift LEDs will return to the
dashboard.
To Next Page
Loading...
