Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 87
Using (2) 14mm wrenches,
adjust the rear hub gear bearing
cups
Between adjustments, check
that the rear hub rotates in the
freewheel direction. The bearing
cup nuts should be tightened
until the wheel does not have
more than 1mm of “free” play
at the rim, and the wheel is able
to rotate freely. This is a matter
of compromise and feel. If in
doubt, consult Gocycle Tech
Support for advice.
Retighten the outer lock nut.
Note: after tightening the outer
lock nut, the hub may need re-
adjusting due to the nature of
the tightening process. You may
need to repeat this process until
you have the desired freeness of
rotation and minimal lateral
play at the rim.
First, loosen the
lock nut.
Second, tighten the
inner adjuster nut.
Retighten the
outer lock nut
Hold the inner nut
stationary
To Next Page
Loading...
