Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 89
8.3
Gears Will Not Shift Down Automatically
Symptom: Whilst decelerating, the gears are not shifting down automatically. Only when completely
stopped does the Gocycle shift to first gear.
Resolution: Check that Predictive Shifting is ON. See 6.2.1Turning Predictive Shifting ON/OFF for
more information.
Resolution: First confirm that Predictive Shifting is ON. The gear will only change automatically when
decelerating from a speed greater than that at which the predictive shift is programmed to change
(e.g., from 3rd gear to 2nd gear at speed 7 LEDs and from 2nd gear to 1st gear at speed 3 LEDs). If you
shift to 3rd gear, but remain below speed 7 LEDs, when decelerating the shifting will not be
automatic. Shift down manually by double-clicking the gear shift button, as you would with a
computer mouse.
8.4
Diagnosis Modes
Your Gocycle is pre-programmed with a number of modes to assist in fault diagnosis, should an issue
occur. Should an issue arise, a Gocycle technical support executive may request you to perform a
number of checks in an attempt to properly diagnose a problem. The following section is for
reference.
Reminder! To select a mode, rotate “wrist down” and selectors A and B until all LEDs flash, then
release both selectors. The mode will then be shown on the dashboard display (C). Rotate “wrist
down” selector B repeatedly until you reach the number of LEDs which represent your desired mode
To Next Page
Loading...
