Gocycle G3 - Adjusting the Bearings on the Rear Hub

Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 85
The QR should have
roughly 120 degrees of
free play before it
beings to engage. The
closing resistance
should act over the
remaining 60 degrees of
movement till it is
firmly shut in the
correct location.
If it is too loose, rotate
the clock-nut clockwise
till the next hole aligns
with the hole in the
stem lower and recheck
Conversely if it is too
tight rotate the clock-nut
anticlockwise to the
next hole and recheck.
Once adjusted so that
the closing resistance
acts upon the final 60
degrees of movement in
the QR reinstall the
securing bolt using a
2.5mm Allen key.
7.14 Adjusting the Bearings on the Rear Hub
It is unlikely that you will need to adjust the bearings on the rear hub. However, in the event that the
rear wheel develops play (more than 1mm at the rim) or it feels heavy to pedal (i.e., the hub is too
tight), you may need to adjust the bearing cone.