Gocycle G3 - LED Reference Tables

Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 96
8.5 LED Reference Tables
8.5.1 Dashboard Display
C
D
E
Battery Charge Level
(Displayed when motor is
OFF)
Gear
Selection
Speed
Energy Consumption Meter
(Displayed when motor is
ON)
Gear
Selection
Speed
8.5.2 Energy Consumption Meter
More LEDS
Greater consumption
Less LEDS
More economical
8.5.3 Battery Charge Level
10–2 LEDs
Full power
Motor will operate at full power
1 FLASHING LED
Power Save
Mode
Motor will operate at reduced
power. See 6.3.2.5 Power
Save.
0 LED
Motor will not operate
8.5.4 Speed
See 6.3.1 Riding Modes Reference Table for more information.
When over-temperature protection is in effect, the speed LEDs (E) will flash and the power will
gradually be reduced to prevent damage to these components. When the temperature of the motor
and/or controller has cooled adequately, the speed LEDs will cease to flash and full power will again
be available. See 6.7 Heat and Over-Temperature Protection for more details.