Gocycle G3 - Page 99

Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 95
8.4.4 Pedal and Wheel Sensor Ratio Check
Follow the next steps to check function of the wheel and pedal sensors in all gears:
Place the Gocycle in a cycle
stand, so the rear wheel and
pedal cranks are free to turn.
Select Pedal and Wheel Sensor Ratio
Check, mode 16.
One LED will flash to confirm
that the Gocycle is ready for the
test to begin.
Whilst applying light braking
pressure to the rear brake, pedal
forward at a recommended 40–60
rpm (revolutions per minute).
The Gocycle will automatically
shift up from 1
st
to 2
nd
gear and
from 2
nd
to 3
rd
gear.
Continue to rotate the pedals at a
constant 40–60 rpm for 25
complete revolutions.
The results of the test will then be
displayed on the dashboard
display. You may be asked to
report these to a technical
support executive.
Exit by rotating “wrist down”
and holding selectors A and B—
the riding mode will flash to
confirm exit.
Mode
Pedal and Wheel Sensor Ratio Check
LED Mode Display
16
Mode Description
Checks the operation of the pedal and wheel
sensors in all gears