Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 61
7.5
Lubrication
There is no need to regularly inspect,
clean and lubricate the internal
components of the Cleandrive
®
The gearbox, rear hub, hub bearings and chain drive system (Cleandrive) are lubricated during
production, and unless the Gocycle is regularly exposed to a high-humidity, corrosion-enhancing
environment, these components will last the lifetime of the product.
7.6
Adjusting the Shifting
From time to time, it might be necessary to adjust your shifting; for example, if you hear a noise from
your rear hub or your Gocycle is not holding in gear. Your Gocycle’s electronic shifting is calibrated
during production, but you can recalibrate it by adjusting the servo electronically as follows:
Once in mode 15, the display
will show the gear selection and
calibration either side of the
factory default
Keeping the pedals still, select
the gear that you are aiming to
adjust with the gear selector B
Now take your Gocycle for a
ride—whilst pedalling, adjust
the gearing by rotating selectors
A or B “wrist down” as
necessary until the gear remains
in place, with no noise from the
rear hub
To Next Page
Loading...
