Gocycle G3 - Adjusting the PitstopWheel Quick Release Cam Levers

Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 68
Replace the six motor cover securing
screws. Tighten to a torque of 3–4Nm.
WARNING! The braking performance
of new brake pads will increase over
time. Ensure that you “bed-in” your
brakes by performing a number of
stops.
7.7.2.2 Replacing the Rear Brake Pads
Locate the two rear calliper securing
bolts, shown.
Slide the calliper off the disk rotor.