REMOTE CONTROL
SHIFT
activates the SELECTION FRAME and selects
the functions, just like you would do by
pressing the knob
POWER ON/OFF
use POWER ON/OFF to turn ON and OFF
the IS-1000 [the master switch on the
rear panel must be ON]
AMP
if the IS-1000 is not responding,
please make sure you have
selected AMP on the remote
BALANCE L/R
use L [Left] and R [Right] to adjust
the balance of the volume by 1dB at
a time on each channel
VOLUME
use VOL+ and VOL- to adjust the
volume level by 1dB at a time
MUTE
use MUTE to instantly mute the IS-
1000 the input selection is disabled
while IS-1000 is in MUTE
INPUT SELECTION
use IN+ and IN- to change the
selected input.
use IN+ and IN- when the SELECTION
FRAME is red [active selection] to
change the function and set the
desired value
DISPLAY
turns ON and OFF the display
USING THE REMOTE CONTROL
IS-1000 is supplied with a Gold Note remote to help you conveniently operate the amplifier without even touching the
knob located on the frontal panel.
With the remote control you can fully access every function just like you would when using the knob.
18
To Next Page
Loading...
Need help?
General
