17
ART MONITOR7/G2+
Door panel call screen
SOU S5110/ART 7 VIDE ENTL O DOOR RY SYSTEM KIT
This screen is displayed when you receive a call or when you press the hidden button below icon of the main
menu. During a call, icon displayed on the screen will blink green (during the call process). In the top centre
of the screen, the date and time are shown and, on the right, the source of the image is displayed (door panel 1,
door panel 2, camera 1 or camera 2). The call has a duration of 45 seconds
.
Press the hidden button below icon to cancel the current call or display and return to the main
menu.
Press the hidden button below icon / to start or end audio communication with the
door panel displayed respectively. Communication has a maximum duration of
90 seconds. Once communication has ended, the screen will turn off" .
Press the hidden button below icon to change the source of the image as long as the system has
more than one door panel or has an external camera connected and display has been activated
(see pp. 32-34). It is possible to make the change during display, call and communication
processes.
A few seconds after receiving a call, it automatically takes a photograph. In the top left of the screen,
icon is displayed and indicator will illuminate. Press the hidden button below icon to
take a picture.
If a Micro SD card is inserted, a 15-second video automatically starts recording a few seconds after
receiving the call. In the top left of the screen, icon is displayed and indicator will illuminate
(see p. 14 to configure video recording mode). Then a short 1-second press on the hidden button
below icon will take a photograph or a long 2-second press will record a video.
0 -0 -21 7 019 11:17:10
1
1 2
Press the hidden button below icon to activate the lock release (or device connected to the CV
output of the door panel) for 3 seconds(factory setting, programmable by the installer; see pp. 32-34 .
During activation, indicator will illuminate.
)
Press the hidden button below icon to activate the lock release (or device connected to the relay
output of the door panel) for 3 seconds ( )factory setting, programmable by the installer; see pp. 32-34 .
During activation, indicator will illuminate.
1
2
1
2
To Next Page
Loading...
Need help?
General
