13
04 Check and Storage
User Manual V1.9-2023-04-30
PCU x 1
Terminal resistor x 1
Protection cover x 1
M5*12 screw x 4
Base x 1 DC connector x N
Expansion
bolt x 4
Normal locking
bracket x N
Grounding
terminal x 2
M5 hexagon
screw x 2
Adjustable
feet x N
Locking bracket (match
adjustable feet) x N
M6 screw x 2
Documents x 1
Power control unit
4.3 Storage
If the equipment is not to be installed or used immediately, please ensure that the storage
environment meets the following requirements:
1. Do not unpack the outer packing box or throw the desiccant away.
2. Complete the equipment installation in three days after unpacking it. Pack and store the
equipment using the original packing box if it is not installed.
3. Stack the equipment complying with the labels and requirements on the packing box.
4. The equipment must be stacked with caution to prevent them from falling.
5. Keep the equipment away from ammable, explosive, and corrosive matters.
6. Place the equipment in a cool place where away from direct sunlight.
7. Store the equipment in a clean place. Make sure the temperature and humidity are
appropriate and no condensation.
8. Storage SOC: 25%~50% SOC. Circle the charge-discharge every 6 months.
9. Recommended storage temperature: 0℃~35℃ (less than one year), -20℃~0℃ or 35℃~45℃
(less than one month).
10. Recommended storage humidity: 0%~95%RH(no condensation). Do not install the battery if
there is any moisture or condensation.
To Next Page
Loading...
Need help?
General
