Gossen MetraWatt R2600 - Page 29

GOSSEN-METRAWATT GMBH 29
High set point SP L ... X2 X2
Parameter disabled
with DIP switch set
as shown
and during
self-optimizing
Low set point X1 ... SP H X1
Maximum regulation ratio –100 ... 100 % 100 0 ... 100 with marking A1
Act. value calibr. (see Calibration) (Auto), –MBU/4 ... +MBU / 4 0 only with marking B1, B3, B4
Location of decimal point 9999, 999•9, 99•99, 9•999 9999 only with marking B2, B5
Upper range limit standard signal rn L ... 9999 100
only with marking B2 ... B5
Lower range limit standard signal –1500 ... rn H 0
Upper range limit Heating current 1.0 ... 99.9 A 42,7
Not for step controller
1)
Calibration position readback See Calibration
For step controller
with position readback
6)
Reg. ratio for actuator operation or
for feedforward control
–100 ... 100 % 0 0 ... 100 with marking A1
Regulation ratio with sensor error –100 ... 100 % 0 0 ... 100 with marking A1
Continuous signal see page 27 0 only with marking A3
Interface address 0 ... 250 250 only with marking F1
1) Only for: marking ≠ A4 and configuration digit „controller type“ ≠ 6
2) Only for: marking ≠ A1 and configuration digit „controller type“ = 4 or 5
3) Only for: marking ≠ A1 and configuration digit „controller type“ = 0, 4, 5 or 6
4) Additional actual value filter for continuous action controller (controller type = 2.3). tc = time constant
5) Only for: marking ≠ A1 and configuration digit „controller type“ = 6
6) Only for: marking = A4 and configuration digit „controller type“ = 6
12345
All parameters
enabled at DIP
switch position shown
12345