THERMAL BARCODE PRINTER SERIES 19
Use “!” as a starting character for the control code followed by three
control codes.
If the start subset is not set, the default starting subset is B.
Ø EAN128 Code 128, switching code subset A, B, C automatically
Ø 25 Interleaved 2 of 5
Ø 25C Interleaved 2 of 5 with check digits
Ø 39 Auto switch full ASCII and standard code 39 for
PLUS models.
Ø 39C Code 39 full ASCII with check digit
Code 39 standard with check digit
Auto switch full ASCII and standard code 39 for
PLUS models.
Ø 39S Code 39 standard
Ø 93 Code 93
Ø EAN 13 EAN 13
Ø EAN 13 + 2 EAN 13 with 2 digits add-on
Ø EAN 13 + 5 EAN 13 with 5 digits add-on
Ø EAN 8 EAN 8
Ø EAN 8 + 2 EAN 8 with 2 digits add-on
Ø EAN 8 + 5 EAN 8 with 5 digits add-on
Ø CODA Codabar
Ø POST Postnet
Ø UPCA UPC-A
Ø UPCA + 2 UPC-A with 2 digits add-on
Ø UPCA + 5 UPC-A with 5 digits add-on
Ø UPCE UPC-E
Ø UPCE + 2 UPC-E with 2 digits add-on
Ø UPCE + 5 UPC-E with 5 digits add-on
Ø CPOST China post code
Ø MSI MSI code
Ø MSIC
Ø PLESSEY PLESSEY code
Ø ITF 14 ITF 14 code
Ø EAN 14 EAN 14 code
Ø height bar code height expressed by dot
Ø human readable 0: human not readable
1: human readable
Control code A B C
096 FNC3 FNC3 NONE
097 FNC2 FNC2 NONE
098
SHIFT
SHIFT NONE
099
CODE C
CODE C
NONE
100
CODE B
FNC4
CODE B
101
FNC4
CODE A
CODE A
102 FNC1 FNC1 FNC1
103
Start (CODE A)
104
Start (CODE B)
105 Start (CODE C)
To Next Page
Loading...
