GPRINTER GP-2120T - Offset

THERMAL BARCODE PRINTER SERIES 4
4. OFFSET
Description
This command defines the selective, extra label feeding length each form
feed takes, which, especially in peel-off mode, is used to adjust label stop
position, so as for label to register at proper places for the intended purposes.
The printer backtracks the extra feeding length before the next run of printing.
Syntax
(1) English system (inch)
OFFSET m
(2) Metric system (mm)
OFFSET m mm
Parameter Description
m The offset distance (inch or mm)
-1≤ m ≤1(inch)
CAUTION: Impropriety offset value may cause paper jam.
Example
(1) English system (inch)
OFFSET 0.5
(2) Metric system (mm)
OFFSET 12.7 mm
See Also
SIZE, GAP, SET PEEL