GPRINTER GP-2120T - Barcode

THERMAL BARCODE PRINTER SERIES 18
21. BARCODE
Description
This command is used to print 1D barcodes on label form.
The available bar codes are listed below:
n Code 128
n Code 128M
n EAN 128
n Interleaved 2 of 5
n Interleaved 2 of 5 with check digit
n Code 39 standard
n Code 39 full ASCII
n Code 39 full ASCII with check digit
n Code 93
n EAN 13
n EAN 13 with 2 digits add-on
n EAN 13 with 5 digits add-on
n EAN 8
n EAN 8 with 2 digits add-on
n EAN 8 with 5 digits add-on
n Codabar
n Postnet
n UPC-A
n UPC-A with 2 digits add-on
n UPC-A with 5 digits add-on
n UPC-E
n UPC-E with 2 digits add-on
n UPC-E with 5 digits add-on
n MSI
n PLESSEY
n China POST
n ITF14
n EAN14
Syntax
BARCODE X, Y, ”code type”, height, human readable, rotation, narrow, wide,
“code”
Parameter Description
x Specify the x-coordinate of the bar code on label
y Specify the y-coordinate of the bar code on label
code type
128 Code 128, switching code subset A, B, C
automatically
128M Code 128, switching code subset A, B, C manually.