GPRINTER GP-9025T - BARCODE

2. BARCODE
Description
This command is used to print 1D barcodes on label form.
The available bar codes are listed below:
 Code 128 (Automatically switch character set)
 Code 128M (Manually switch character set)
 EAN 128 (Automatically switch character set)
 Interleaved 2 of 5
 Interleaved 2 of 5 with check digit
 Code 39 standard
 Code 39 full ASCII
 Code 39 full ASCII with check digit
 Code 93
 EAN 13
 EAN 13 with 2 digits add-on
 EAN 13 with 5 digits add-on
 EAN 8
 EAN 8 with 2 digits add-on
 EAN 8 with 5 digits add-on
 Codabar
 Postnet
 UPC-A
 UPC-A with 2 digits add-on
 UPC-A with 5 digits add-on
 UPC-E
 UPC-E with 2 digits add-on
 UPC-E with 5 digits add-on
 MSI
 PLESSEY
 China POST
 ITF14
 EAN14
Syntax
BARCODE X, Y, ”code type”, height, human readable, rotation, narrow, wide,
“code”
Parameter Description
x Specify the x-coordinate of the bar code on label
y Specify the y-coordinate of the bar code on label
code type
128 Code 128, switching code subset A, B, C
automatically
128M Code 128, switching code subset A, B, C manually.