8
You can hold the meter at the lower part of the meter, or just simply place the meter to the
location where is close to the target source.
Hardware setup
1. Pressing the power key (S4) for 1 second will show the battery level. Charge the battery fully before
the first use. It may take a few hours to get the battery fully charged. Check the battery icon on the
display, a fully charged battery icon will be filled with solid color, without flashing.
2. Power up the unit. Pressing the power key (S4) for 2 seconds will turn on the unit.
3. Set the backlight timeout (in seconds), in order to minimize the power consumption.
4. You can hand hold and meter or place to the location to measure. The sensors should always point to
the source. See above diagram.
5. Now the unit is ready to use. You should see the background EMF/EF/RF reading.
For technical questions and support, please use the forum at the following link:
http://www.GQElectronicsLLC.com/forum
For the latest version user guide, please visit our software download page:
http://www.gqelectronicsllc.com/comersus/store/download.asp
To Next Page
Loading...
Need help?
General
