308-68516
Maintenance
WARNING
INJECTION
HAZARD
T
o reduce the risk of serious injury
,
whenever you are instructed to relieve
pressure, follow the
Pressure Relief
Procedure
on page 17.
CAUTION
For detailed engine maintenance and specifications,
refer to the separate engine manual, supplied.
DAILY:
Check the engine oil level and fill as neces
-
sary.
DAILY:
Check and fill the gas tank.
AFTER THE FIRST 20 HOURS OF OPERA
TION
Drain the oil and refill with clean oil.
WEEKLY:
Remove the cover of the air filter and
clean the element. Replace the element, if necessary
.
If operating in an unusually dusty environment, check
the filter daily and replace it, if necessary
.
Replacement elements may be purchased from your
local Honda dealer
.
WEEKLY:
Check the level of the TSL in the displace
-
ment pump packing nut. Fill the nut, if necessary
. Keep
TSL in the nut to help prevent fluid buildup on the
piston rod and premature wear of the packings.
Monthly:
Remove the front cover (9) and fill the
cavity in the connecting rod with non-detergent motor
oil 1/4 in. below the surface. See Fig. 7.
AFTER EACH 100 HOURS OF OPERA
TION:
Change the oil. Refer to the engine manual for addi
-
tional maintenance instructions.
SP
ARK PLUG
:
Use only an (NGK) BPR6ES or a
(NIPPONDENSO) W20EPR-U plug. Gap the plug to
0.028 to 0.031 inch (0.7 to 0.8 mm). Use a spark plug
wrench when installing and removing the plug.
Fig. 7
Fill to .25 in. below sur
-
face with non-detergent
motor oil.
9
06922
To Next Page
Loading...
