Registering the Meter
313046A 7
e. The meter resets and returns to it’s initial
screen.
NOTE: If the meter is not able to communicate with the
PC during registration, the message NO SIGNAL or NO
PC SIGNAL appears on the meter display.
NO SIGNAL message means:
• There is no RF signal between the PC and
Meter.
• The meter is out of the RF Signal range.
• The Transceiver does not have power.
• Either the NETWORK ID and/or TRANS-
CEIVER ID information is not correct in the
meter and the correct information must be pro-
vided.
NO PC SIGNAL message means:
• The Matrix Client isn’t running.
• The cable is not connected between the PC and
Transceiver.
f. After the information is programmed into the
electronic meter, the meter can be connected to
the dispensing hose.
NOTE: If the programmed parameters need to be
changed, the meter must be reprogrammed.
To Next Page
Loading...
