EasyManuals Logo

Graco E Series User Manual

Graco E Series
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
HIGH
PRESSURE SPRAY CAN CAUSE SERIOUS INJURY.
FOR
PROFESSIONAL USE ONLY. OBSERVE ALL WARNINGS
Read and understand
all
instruction manuals before operating equipment.
FLUID INJECTION HAZARD
General
Safety
Safety
Latch
the gun, leaks or ruptured components can inject fluid through gun safety latch in the closed or"safe"position, making the gun
This equipment generates very high fluid pressure. Spray from
Wheneveryoustopspraying,evenforamoment,
alwayssetthe
yourskin and into your body and causeextremelyserious bodily inoperative. Failure
to
set the safety latch can result in acciden
-
injury, including the need for amputation. Also, fluid injected or tal triggering of the gun.
splashed into the eyes or on the skin can cause serious dam
-
age.
Diffuser
NEVER pointthespray gunat anyoneorat any partofthe body,
The gun diffuser breaks up spray and reduces the risk of fluid
NEVER put hand or fingers Over the spray tip. NEVER
try
to
injection when the tip is not installed. Check diffuser operation
"
blow back
"
paint; this is NOT an air spray system.
regularly. Follow the Pressure Relief Procedure, below, then
ALWAYS have the tip guard in place
on
the spray gun when gunfirmlytothepail.
Usingthelowestpossiblepressure,trigger
remove the spray tip. Aim the gun into a metal pail, holding the
spraying. the gun.
If
the fluid emitted is not diffused into an irregular
ALWAYSfollow the Pressure Relief Procedure,
below;
before
stream*
replace
the
diffuser
immediately'
cleaning or removing the spray tip or servicing any system
Tio
Guard
NEVER
try
to'stop or deflect leaks with your hand or body.
each use.
Be sure equipment safety devices are operating properly before
Medical
Alert
-
Airless Sarav Wounds
If
any fluid appears
to
penetrate your skin. get
EMERGENCY
MEDICAL
CARE
AT ONCE.
DO
NOT
TREAT
AS
A
SIMPLE
.
.
.
-
-.
-
-.
. .
.
-.
.
.
.
.
.
.
.
- -
-,-~-,
~ ~~~~~~
CUT.
Tell the doctor exactly what fluid was injected.
Note to Physician: Injection in the skin is a traumatic inju
It is
important to treat the injury surgically as
soon
as possibr. Do
with some exotic coatinos iniected directlv into the blood
not
delay treatment to research toxicity. Toxicity
is
a concern
stream. Consultation with
-
a plistic surgeon br reconstructive
hand surgeon may be advisable.
Be sure all gun safety devices are operating properly before
Spray
Gun
Safety Devices
each use. Do
not
remove or modify any part of the gun; this can
cause a malfunction and result in serious bodily injury.
ALWAYS have the tip guard in place
on
the spray gun while
spraying. The tip guard alerts you
to
the fluid injection hazard
and helps reduce, but does not prevent, the risk of accidentally
placing your fingers or any part of your body close
to
the spray
tip.
Trigger
Guard
Always have the trigger guard in place
on
the gun when spray
-
ing
to
reduce the risk of accidentally triggering the gun
if
it
is
dropped or bumped.
Spray
Tip Safety
the spray tip clogs while spraying. engage the gun safety latch
Use extreme caution when cleaning or changing spray tips.
If
immediately. ALWAYS foilow the Pressure Relief Procedure
and then remove the spray tip to clean
it.
fully relieved and the gun safety latch is engaged.
NEVER wipe
off
buiid-up around the spray tip until pressure is
.~
~ ~
Pressure Relief
Procedure
3.
Disengage the gun safety latch. Hold a metal art of the
To reduce the risk of serious bodily injury, including fluid in
-
~
'
. gun firmly to the side of a grounded metal pair and trig-
jection,splashingfluidorsolventintheeyesorontheskin,or
injury from moving Darts or electric shock, always follow this
4.
Enoage the aun safetv latch.
ger the gun
to
relieve pressure.
I
procedure whenever
YOU
shut
Off
the sprayer, when check-
5.
OGnihepre&uredra-invalve,
having acontainerready
ingorservicinganypartofthespraysystem,wheninstalling,
cleaning
or
changing spray tips, and whenever you stop
to catch the drainage. Leave the valve
open
until you are
ready
to
spray again.
I
spraying.
1.
Engage the gun safety latch.
2.
Turn the ON/OFF switch
to
OFF,
clogged,orthatpressurehasnotbeenful~relievedafterfol-
If
you
suspect that the spray tip or hose
is
completely
lowinqthestepsabove,VERYSLOWLYloosenthetiDauard
I
retai6n nut'or hose end coupling and relieve pi&sure
gradual
9
y,
then loosen completely. Now clear the tip or hose.
I
I
9
i
,
4
307-670

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Graco E Series and is the answer not in the manual?

Graco E Series Specifications

General IconGeneral
BrandGraco
ModelE Series
CategoryPaint Sprayer
LanguageEnglish

Related product manuals