SETUP
5.
Plug
in
the Sprayer.
Be sure the
ONlOFF
switch is
7.
Prepare the
paint
according
to
the manufacturer's
OFF.
Then plug the cord into a grounded electrical
outlet at least
6
m away from the spray area.
recommendations.
a. Remove any skin that may have formed.
WARNING
the risk of fire or explosion which can result in seri-
Proper electrical grounding is essential
to
reduce
ous
bodily injury and property damage. Refertothe
warning section
FIRE
OR
EXPLOSION HAZARD
on page
5
for more detailed grounding instructions.
f
I
6.
Flush the pump
to remove the lightweight oil which
was left in
to
protect pump parts after factory testing.
a. Before using water
-
base paint, flush with min
-
eral spirits followed by soapy water, and then a
clean water flush.
b. Before using oil
-
base paint, flush with mineral
c. See
FLUSHING GUIDELINES
on page
11
&
12
spirits only.
for the flushing procedure.
-.
b. Stir the paint
to
mix pigments.
c.. Strain the paint through a fine nylon mesh bag
(available at most paint dealers)
to
remove parti
-
cles that could clog the filter or spray tip. This is
probably the most important step toward
trouble
-
free spray painting.
307470
7
To Next Page
Loading...
Need help?
General
