Clean Up
24 334558D
Clean Up
1. Perform Pressure Relief Procedure,
page 13, steps 1-7.
2. Remove Guard and SwitchTip.
3. Remove siphon tube set from paint and
place in flushing fluid. Use water for
water-based paint and mineral spirits
for oil based paint.
4. Turn engine ON and start engine or
plug motor in and turn ON. Move throt-
tle to MAX on internal combustion
engine. Turn hydraulic pump valve ON.
Turn prime valve to SPRAY position.
5. Hold gun against pail. Disengage trig-
ger lock. Turn pressure control up until
motor begins to drive pump. Trigger
gun until flushing fluid appears.
6. Move gun to waste pail, hold gun
against pail, trigger gun to thoroughly
flush system. Release trigger and
engage trigger lock.
To Next Page
Loading...
