Graco LineLazer GM 5000 - Positioning the Gun Arm Assembly; Vertical Position of the First or Second Gun; Horizontal Position of the First Gun

17308-105
Positioning the Gun Arm Assembly
D
93
405B
405A
404
4
ENGINE
SIDE PUMP SIDE
B
“WINGS” OF TIP GUARD
B
E
A
D
DETAIL A
1
402
Fig. 15

0012D
The gun arms can be positioned for a variety of spraying
needs. The drawings on page 19 primarily show the guns
mounted on the pump side of the Linestriper . However,
one
or both guns may be mounted on the engine side.
Whenever Y ou Move the Guns
CAUTION
Do not kink the cables, which could prevent them
from properly triggering and untriggering the guns.
Disengage the trigger cables and engage the gun trigger
safety latch first. See page 21. Do not kink the trigger
cables.
Pull out more of the 50 ft. hose, if necessary .
After moving the guns, reposition the spray tip guard so
it is parallel to the ground and its “wings” face the front
and back of the unit. Disengage the gun trigger safety
latch and engage the trigger cable.
V ertical Position of the First or Second Gun
Loosen the arm clamp (6) and move the gun up or down.
Tighten the clamp. Engage the trigger cable.
Horizontal Position of the First Gun
Method 1: Disengage the trigger cable. Loosen the car-
riage clamps (B,D) and slide the carriage bar (4) left or
right, so the gun will be outside the tire path. T ighten the
clamps. Engage the trigger cable.
Method 2: Disengage the trigger cable. Loosen the arm
clamp
(6) and rotate the gun out to the side. T ighten the
bolt. Engage the trigger cable.
NOTE: Use methods 1 and 2 together to obtain the max -
imum
distance of one gun from the unit, which is helpful
when spraying around obstacles.
Horizontal Position of the Second Gun
Method 1: Disengage the trigger cable. Loosen the
clamps (405A, 405B). Slide the second gun bar (404)
horizontally, being sure both clamps engage the second
gun bar. T ighten the clamps. Engage the trigger cable.
Method 2: Disengage the trigger cable. Loosen the arm
clamp
(6) and rotate the gun out to the side. T ighten the
bolt. Engage the trigger cable.
NOTE: Use methods 1 and 2 together to obtain the max -
imum distance of 33–
1
/
2
in. (851 mm) between the center
of two guns.