Maintenance
WARNING
T
o reduce the risk of serious injury always follow
the
Pressure Relief Procedure
on page 7,
before checking, adjusting, cleaning, or shutting
down the LineLazer
.
CAUTION
For detailed engine maintenance and specifications,
refer to the separate HONDA engine manual.
Daily: Check
the
engine oil level and fill as necessary
.
Daily: Check
and fill the gas tank.
After the first 20 hours of operation and each 100
hours
thereafter:
Change the oil.
Weekly: Remove
the air filter cover and clean the ele
-
ment. In very dusty environments, check the filter daily.
Replace
the element as needed. Replacement elements
can
be purchased from your local HONDA dealer
.
Weekly: Check the level of the TSL in the displace-
ment pump packing nut. Fill the nut, if necessary. Keep
TSL
in the nut to help
lubricate the pump packings. See
page
8.
Weekly: Use
a grease gun to grease the zerks (32) on
this unit. The grease purges pivot areas of paint
buildup.
See
Fig. 22.
Spark plug: Use only a (NGK) BP6ES or BPR6ES
plug.
Gap the plug to 0.025 to 0.030 in. (0.7 to 0.8
mm).
Always
use a spark plug wrench.
One
zerk on each gun holder
One zerk on caster latch
One zerk on caster lever
One zerk on dual gun selector
Fig.
22
One
zerk on wheel
02154C
To Next Page
Loading...
