Trigger
Cable & Dual Gun
Selector Operation
Trigger
Cable T
ension Adjustment
See
Fig.
21
1. Relieve
pressure. See page 7.
2. Be
sure the gun is properly mounted in the holder as
instructed
on page 20.
3. Pull
the actuator lever (94) forward and hold it. Lift up
on
the gun trigger (A) until there is slight
resistance.
Visually
check to see if there is about 1/32
to 1/16 in.
(1–2 mm) gap between the trigger lever (B) and
where
the gun trigger touches the bar
.
4. To adjust the tension, loosen the screw (C) in the
block (48). Slide the block forward to increase the
gap
and backward to decrease the gap. T
ighten the
screw.
5. Recheck
the gap and adjust as needed.
CAUTION
Do not allow the cable (402) to rub against the
outside edges of the slot (H) in the block (48), to
prevent premature wear of the cable. Rotate the
block slightly to eliminate rubbing. See Fig. 21
DET
AIL A.
1 or 402
48
1/32
– 1/16”
(1–2 mm)
94
A
B
FORWARD
Be sure end jacket of cable
seats here. keep jacket and
seat clean
1
or 402
48
45
45
C
DET
AIL A
0023
0024
Fig. 21
To Next Page
Loading...
