6 308-105
WARNING
FIRE AND EXPLOSION HAZARD
Improper
grounding, poor ventilation, open flames or sparks can cause a hazardous condition and
result in a fire or explosion and serious injury
.
If there is any static sparking or you feel an electric shock while using this equipment,
stop spray-
ing immediately
.
Do not use the equipment until you identify and correct the problem.
Provide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid
being sprayed.
Keep the spray area free of debris, including solvent, rags, and gasoline.
Disconnect all electrical equipment in the spray area.
Extinguish all open flames or pilot lights in the spray area.
Do not smoke in the spray area.
Do not turn on or of
f any light switch in the spray area while operating or if fumes are present.
Do not operate a gasoline engine in the spray area.
Ground the sprayer to a true earth ground with the ground wire and clamp (supplied).
Use only electrically conductive hoses.
MOVING
P
ARTS HAZARD
Moving
parts can pinch or amputate your fingers.
Keep clear of all moving parts when starting or operating the sprayer
.
Before servicing the equipment, follow the
Pressure Relief Procedure
on page 7 to prevent the
equipment from starting unexpectedly
.
To Next Page
Loading...
Need help?
General
