Graco LineLazer IV 200HS - Fan Belt Service; Belt Removal and Installation

311021 19
Engine
Removal
1. Relieve pressure; page 7.
2. Remove throttle cable from engine.
3. Do Fan Belt, Removal; page 18.
4. Loosen hand nut (241). Swing bracket (30) out.
5. Fig. 6. Disconnect blue, brown and orange leads
from engine (185).
6. Remove engine and rocker plate (87c) from spray-
er.
7. Remove four screws (189), washers (114), wash-
ers (170) and nuts (118) and remove rocker plate,
dampeners (59) and washers (114) from engine.
Installation
1. Install rocker plate (87c), dampeners (59) and
washers (170), washers (114) on engine (185)
with four screws (189), washers (170) and nuts
(118); torque to 20 ft-lb (27.1 N·m).
2. Install engine and rocker plate (87c) on sprayer.
3. Connect blue, brown and orange leads.
4. Do Fan Belt, Installation; page 18.
5. Swing motor retainer bracket (30) in. T ighten hand
nut (241).
ti6520a
GREEN
GREY
BROWN
BLUE
ORANGE
Fig. 6
NOTE: All service to the engine must be
performed by an authorized HONDA dealer.
189
30
241
114
59
170
118
114
87c