Graco LineLazer IV 200HS - Oil;Filter Change

31102122
Oil/Filter Change
Removal
1. Fig. 8. Place drip pan or rags under sprayer to
catch hydraulic oil that drains out.
2. Remove drain plug (195). Allow hydraulic oil to
drain.
3. Unscrew filter (199) slowly -- oil runs into groove
and drains out rear.
Installation
1. Install drain plug (195). Apply a light coat of oil to
oil filter gasket and install oil filter (199). Tighten oil
filter 3/4 turn after gasket contacts base.
2. Fill with1.25 gallons (4.73 liters) of Graco hydraulic
oil 169236 (5 gallon/20 liter) or 207428 (1 gal-
lon/3.8 liter)
3. Check oil level.
Fig. 8
ti2271a
199
Gallon Counter
Removal
1. Fig. 9. Disconnect gallon counter cable at back of
pressure control and at engine.
2. Remove guard (137) and reed switch from hydrau-
lic motor.
Fig. 9
137
ti6512a
3. Fig. 11 -- 13. Remove pump.
4. Fig. 10. Remove ring magnet (150).
Fig. 10
222
ti6513a
Installation
1. Fig. 10. Install new ring magnet (222) with dimple
marks facing down.
2. Fig. 14 -- 16. Install pump.
3. Install new reed switch and guard (137) on hydrau-
lic motor.
4. Fig. 9. Connect gallon counter cable at back of
pressure control and at engine.