LED Display
32 3A6342A
LED Display
(not included on all models)
Operation Main Menu
Short press
DISPLAY
button to move to
next display. Press and hold to change
units or reset data.
1. Perform the Pressure Relief
Procedure, page 19.
2. Turn power ON. LED Display will show
dashes if pressure is less than 200 psi
(14 bar, 1,4 MPa).
Change Display Units
Press and hold the DISPLAY button for
5 seconds to change pressure units
(psi, bar, MPa) to desired units.
Selection of bar or MPa changes
gallons to liters x 10. To change
display units LED Display must be in
pressure display mode and pressure
must be at zero (dashes displayed).
To Next Page
Loading...
Need help?
General
