Repair
Repair Fluid Temperature Sensor
(FTS)
Installation
The Fluid Temperature S ensor (FTS) is supplied with
the system. Install FTS between main hose and
whip hose. See Heated Hose manual 309572 for
instructions.
Figure 9
Test/Removal
1. Perform Shutdown, page 5 0.
2. Remove tape and protective covering from FTS.
Disconnect hose cable (F).
3. If FTS is not reading properly a t the end of the
hose, see Check RTD Cables and FTS, page 61.
4. If FTS fails, replace FTS.
a. Disconnect air hoses (C,L) and electrical
connectors (D).
b. Disconnect FTS from whip hose (W) and
fluid hoses (A, B).
c. Remove ground wire (K) from ground screw
on underside of FTS.
d. Remove FTS probe (H) from component A
(ISO) side of hose.
62 334946A
To Next Page
Loading...
Need help?
General
