Pressure Relief Procedure
311075V 29
Pressure Relief
Procedure
Shutdown
1.
Engage piston safety lock or trigger
safety lock.
2.
Set function knob to Stop/Park .
3.
Turn Recirc/Spray valves to Recirc.
Fluid will be dumped to supply tanks.
Pumps will move to the bottom of their
stroke. Ensure gauges drop to 0.
Fusion
MD2
ti10442a
For longer breaks (more than 10 min-
utes), use the following procedure. If
you will be shut down for more than 3
days, first see Flushing, page 31.
1.
Follow all steps of Pressure Relief Pro-
cedure, at left.
2.
If using an impingement mix gun, close
gun fluid valves A and B. Doing this will
keep the internal parts of the gun
cleaner and prevent crossover.
3.
Shut off Heater Power (heated units
only).
4.
Shut off Motor Power.
5.
Refer to your separate gun manual and
perform the Shutdown procedure.