Access Auto Display Screens
8 407061B
Test Mode Simulation
1. Enable Pump Test or Batch Test.
2. Press Start. The left side A letter will flash.
3. Press . The right side B letter will flash.
4. Press . The Test Result screen will display.
NOTE: The fluid weight or volume can then be entered.
Other Simulations
Spray Mode, Run Mode, Park Mode
Pumps will move up and down on the Alarm Information
screen.
Pressure Tank Control Mode
Tank level will go up and down.
Temperature Control Mode
Temperature will rise from room temperature to setpoint
entered.
To Next Page
Loading...
