Graco ThermoLazer 300TC - Screed Box Installation - FlexDie

Screed Box ThermoLazer 200/200TC (FlexDie)
3A1319K 23
Screed Box ThermoLazer 200/200TC (FlexDie)
Installation
1. Shut off screed box burners.
2. Remove bolt (a) and slide FlexDie into place.
3. Replace and tighten bolt (a).
4. Attach spring loaded handle (Z) to the yoke (31) and
turn 90 degrees to lock into place.
5. Attach both gas hoses to quick release couplings
(10).
6. Re-light screed box burners as required (see
Screed Box Burner Lighting, page 21).
Use extreme caution when installing and removing
screed box. Expect all equipment components and
material to be extremely hot. See MSDS for Thermo-
plastic Traffic Marking Compound.
ti122669a
Front
Rear
ti22670b
a
ti22671b
a
Z
31
ti22672a
ti22673a
10
10