Startup
20 3A9095C
9. Hold a metal part of the spray gun
against grounded metal waste pail.
Trigger gun until paint appears.
10. Move gun to paint pail and trigger for 20
seconds. Release trigger and allow
sprayer to build pressure. Engage
trigger lock.
11. Inspect airless hose connections for
leaks. If leaks occur, perform Pressure
Relief Procedure, page 14, then tighten
all fittings and repeat Startup procedure.
If there are no leaks continue with the
next step.
12. Follow Spray Tip Installation, page 21.
For gun assembly instructions, see
separate gun manual.
High-pressure spray is able to inject
toxins into the body and cause serious
bodily injury. Do not stop leaks with hand
or rag.
To Next Page
Loading...
Need help?
General
