Operation
22 3A9095C
Spray
When RAC X™ Low Pressure Switch Tips
(FFLP, FLP and WRLP) are used, spraying
pressure can be lowered. Spraying at a lower
pressure results in less overspray and
reduces spray tip wear. Adjust the sprayer
pressure to minimize overspray.
1. Spray test pattern. Adjust pressure to
eliminate heavy edges.
2. Use smaller tip size if pressure
adjustment cannot eliminate heavy
edges.
3. Hold gun perpendicular, 10-12 in.
(25-30 cm) from surface. Spray back
and forth; overlap by 50%.
4. Trigger gun after moving. Release
trigger before stopping. For additional
spraying information, see separate gun
manual.
Spraying with atomized,
evenly distributed fan
pattern
Spraying with tails
To Next Page
Loading...
Need help?
General
