Digital Display
28 3A9095C
3. Serial code will scroll across display.
4. Short press menu button and the total
motor run hours is displayed.
5. Short press menu button and the last
error code is displayed: e.g., E=03.
Press and hold menu button to clear
error code to zero.
6. Short press to move to Watchdog.
7. Press and hold menu button to change
Watchdog sensitivity setting (High,
Medium, Low). Default is set to Medium.
8. Short press menu button to move
software Rev.
9. Short press menu button to move to
Sprayer ID.
10. Short press menu button to move to
Knob Calibration, page 29 and
Transducer Calibration, page 29.
11. Turn ON/OFF switch to OFF position to
exit Stored Data.
To Next Page
Loading...
