43
b i o l ine
43
FP – Activation/deactivation of low temperature protection
Press and hold + for more than 3 seconds
Press several times until “FP” is shown in the display
Press to select “FP”. “Act” is now shown in the display
Press to select “Act”
Press or to activate/deactivate [1 = activated / 0 = deactivated]
Press to conrm the set value
Leave the user menu by pressing several times until the cabinet temperature is shown in the display
FP – Setpoint of low temperature protection
Press and hold + for more than 3 seconds
Press
several times until “FP” is shown in the display
Press
to select “FP”. “Act” is now shown in the display
Press
several times until “SEt” is shown in the display
Press
to select “SEt”
Press or to select the setpoint temperature for the low temperature protection
Press to conrm the set value
Leave the user menu by pressing several times until the cabinet temperature is shown in the display
FP – Test of low temperature protection
Press and hold + for more than 3 seconds
Press several times until “FP” is shown in the display
Press to select “FP”. “Act” is now shown in the display
Press to progress to “tES”
Press to select “tES” – test will then be performed
Leave the user menu by pressing several times until the cabinet temperature is shown in the display
FP – Temperature of low temperature protection sensor
Press and hold + for more than 3 seconds
Press several times until “FP” is shown in the display
Press to select “FP”. “Act” is now shown in the display
Press several times until “Pre” is shown in the display
Press to select “Pre”
Press to show the low temperature protection sensor temperature
Leave the user menu by pressing several times until the cabinet temperature is shown in the display
Electric low temperature protection
To Next Page
Loading...
Need help?
General
