Need help?Do you have a question about the Gram BioCompact II and is the answer not in the manual?
General| Brand | Gram |
|---|---|
| Model | BioCompact II |
| Category | Laboratory Equipment |
| Language | English |
On/Off, temperature setting, and lighting controls.
Navigation and display codes for user menu and alarms.
Explains alarm codes, acknowledgment, history, and resets.
Accessing sensor values and interpreting error codes.
Guidelines for proper use and potential hazards.
Identifies key parts of the BioCompact II 210, 310, 410 models.
Visual identification of main components for the BioCompact II 610.
Steps for initial setup and recommended installation environment.
Instructions for fitting the anti-tilt bracket for safety.
Recommended clearances and environmental considerations.
How to connect and configure voltage-free contacts.
Procedures and safety for connecting the cabinet to mains power.
Mandatory steps for equipotential bonding in ATEX zones.
Overview of the digital display and primary control buttons.
Introduction to navigating menus and setting parameters.
Detailed steps for configuring local and external alarms.
Procedures for sensor offsets, low-temp protection, and alarm limits.
Explains error codes and procedures for alarm acknowledgment.
Managing alarm history and resetting max/min values.
Guide to setting LHL and LLL values for local alarms.
Setting delay times for local high and low temperature alarms.
Managing the local door alarm and its delay setting.
How to toggle the audible notification for local alarms.
Procedures for configuring external temperature alarm thresholds.
Setting delay times for external high and low temperature alarms.
Managing the external door alarm and its delay setting.
How to toggle the audible notification for external alarms.
Explanation of sensor offset and its use in measurements.
Step-by-step guide for offsetting A, E, and F sensors.
How to choose between fixed and setpoint-linked alarm limits.
Adjusting the frequency of defrost cycles per 24 hours.
Method for selecting the sensor displayed on the control panel.
Activating, setting, and testing the low temperature protection feature.
Procedures for cleaning the interior and exterior of the cabinet.
Importance, cleaning, and replacement of door gaskets.
Essential safety rules when performing maintenance.
Information found on the unit's identification plate.
How defrost water is managed and tray maintenance.
Instructions for fitting external sensors via the rear access port.
Guidelines for the correct disposal of electrical and electronic equipment.
Information on obtaining GMP qualification documents online.
Electrical wiring diagram for the BioCompact II 210, 310, and 410 models.
Wiring diagram for the BioCompact II RR610 with a solid door.
Wiring diagram for the BioCompact II RF610 with a solid door.
Wiring diagram for the BioCompact II RR610 with a glass door.
Wiring diagram for RR610 Solid Door including Low Temp Protection.
Wiring diagram for RR610 Glass Door including Low Temp Protection.
Diagram illustrating the refrigeration system's piping components and flow.
To Next Page
