Firmware version 1.0.0.31 DP715/DP710 User Manual Page 29 of 56
BASIC OPERATIONS
UNDERSTANDING DP715/710 VOICE PROMPT
DP715 Base Station has a built-in voice prompt menu for simple device configuration. The IVR menu work
with any Handset registered to the base. Pick up the handset and dial “***” to use the IVR menu.
Table 9: DP715/710 IVR MENU DEFINITIONS
Press “*” for the next menu option
Press “#” to return to the main menu
Enter 01-05, 07,10, 13-17,47 or 99 menu options
“Static IP Mode”
Press “9” to toggle the selection
If using “Static IP Mode”, configure the IP address information using
menus 02 to 05.
If using “Dynamic IP Mode”, all IP address information comes from
the DHCP server automatically after reboot.
“IP Address “ + IP address
The current WAN IP address is announced
If using “Static IP Mode”, enter 12 digit new IP address. You need to
reboot the DP715 for the new IP address to take Effect.
“DNS Server “ + IP address
Press “9” to move to the next selection in the list:
• PCM U / PCM A
• iLBC
• G-726
• G-723
•
Announces the Mac address of the unit.
Firmware Server IP
Address
Announces current Firmware Server IP address. Enter 12 digit new
IP address.
Configuration Server IP
Address
Announces current Config Server Path IP address. Enter 12 digit
new IP address.
Upgrade protocol for firmware and configuration update. Press “9” to
toggle between
/
Firmware version information.
Firmware Upgrade
Firmware upgrade mode. Press “
” to toggle among the following
three options:
- always check
- check when pre/suffix changes
Enter the target IP address to make a direct IP call, after dial tone.
(See “Make a Direct IP Call”.)
“RESET”
Press “9” to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu