Grandstream Networks DP715 User Manual

Firmware version 1.0.0.31 DP715/DP710 User Manual Page 41 of 56
Core Dump
Download core dump file for troubleshooting when necessary.
ADVANCED USER CONFIGURATION
Log in to the advanced user configuration page the same way as for the basic configuration page. The
password is case sensitive and the factory default password for Advanced User is “admin”.
Advanced User configuration includes the end user configuration and the advanced configurations
including: a) SIP configuration, b) Codec selection, c) NAT Traversal Setting and d) other miscellaneous
configuration. DP715 has two (2) profiles for the five (5) Handsets.
Table 13:ADVANCED SETTINGS
Admin Password
This contains the password to access the Advanced Web Configuration page. This field is
case sensitive. Only the administrator can configure the “Advanced Settings” page.
Password field is purposely left blank for security reasons after clicking update and saved.
The maximum password length is 25 characters.
Layer 2 QoS
Set values for
802.1Q/VLAN Tag (0-4094)
SIP 802.1p (0-7)
RTP 802.1p (0-7)
STUN Server
IP address or Domain name of the STUN server.
Keep-alive interval
This parameter specifies how often the DP715 sends a blank UDP packet to the SIP
server in order to keep the “hole” on the NAT open. Default is 20 seconds. Minimum
value is 20 seconds.
Use STUN to detect
network connectivity
Use STUN keep-alive to detect WAN side network problems. If keep-alive request does
not yield any response for configured number of times, the device will restart the TCP/IP
stack. If the STUN server does not respond when the device boots up, the feature is
disabled. Default setting is No.
Firmware Upgrade
and Provisioning
Enables DP715 to download firmware or configuration file through either TFTP, HTTP or
HTTPS server.
Via TFTP Server
This is the IP address of the configured TFTP server. If selected and it is non-zero or not
blank, the DP715 retrieves the new configuration file or new code image from the
specified TFTP server at boot time. After 5 attempts, the system will timeout and will start
the boot process using the existing code image in the Flash memory. If a TFTP server is
configured and a new code image is retrieved, the new downloaded image is saved into
the Flash memory.
Note: Please do NOT interrupt the TFTP upgrade process (especially the power supply)
as this
will damage the device. Depending on the local network, this process can take up
to 15 or 20 minutes.
Via HTTP / HTTPS
Server
The URL for the HTTP/HTTPS server used for firmware upgrade and configuration via
HTTP.
For example, http://provisioning.mycompany.com:6688/Grandstream/1.0.0.67“:6688” is
the specific TCP port where the HTTP or HTTPS server is listening; it can be omitted if
using default port 80.
Note: If Auto Upgrade is set to No, DP715 will only do HTTP/HTTPS download once at
boot up.
Firmware Server Path
IP address or domain name of firmware server.

Grandstream Networks DP715 Specifications

General

Brand	Grandstream Networks
Model	DP715
Category	IP Phone
Language	English