2. Select Active under the Hunting Group drop box for FXS port 1.
3. For the remaining ports (say 2, 3 and 4) select 1 for Hunting Group. Ports 2, 3 and 4 are now active members of the
hunting group associated with port 1.
This configuration will route all calls directed to FXS port 1 to ports 2, 3 and/or 4 in round robin fashion respectively if port 1 is
busy or times out. You can configure the ring timeout on the Profile page.
Example configuration of a multiple Hunting Group:
FXS Port #1: SIP UserID and Authenticate ID entered, Hunting Group set to “Active”
FXS Port #2: SIP UserID and Authenticate ID left blank, Hunting Group set to “1”
FXS Port #3: SIP UserID and Authenticate ID left blank, Hunting Group set to “1”
FXS Port #4: SIP UserID and Authenticate ID entered, Hunting Group set to “Active”
FXS Port #5: SIP UserID and Authenticate ID left blank, Hunting Group set to “4”
FXS Port #6: SIP UserID and Authenticate ID left blank, Hunting Group set to “4”
FXS Port #7: SIP UserID and Authenticate ID entered, Hunting Group set to “Active”
FXS Port #8: SIP UserID and Authenticate ID left blank, Hunting Group set to “7”
…
Hunting Group 1 contains ports 1, 2, 3. Hunting Group 4 contains ports 4, 5, 6.
Hunting Group 7 contains ports 7, 8.
Please be aware, the choice of 1 for ports 2 and 3, the choice of 4 for ports 5 and 6, the choice 7 for port 8 is required to
indicate that the SIP account tied to port marked as “Active” will be used for all members of the same Hunting group.
Needless to say, those members of the same Hunting group may not be sequential ports. In following example ports 3, 5 and
7 tied to SIP Account configured in Port #1 marked as “Active”, and ports 4,6,8 tied to SIP Account configured in Port #2
marked as “Active” as well.
Example of not sequential configuration of a multiple Hunting Group:
FXS Port #1: SIP UserID and Authenticate ID entered, Hunting Group set to “Active”
FXS Port #2: SIP UserID and Authenticate ID entered, Hunting Group set to “Active”
FXS Port #3: SIP UserID and Authenticate ID left blank, Hunting Group set to “1”
FXS Port #4: SIP UserID and Authenticate ID left blank, Hunting Group set to “2”
FXS Port #5: SIP UserID and Authenticate ID left blank, Hunting Group set to “1”
FXS Port #6: SIP UserID and Authenticate ID left blank, Hunting Group set to “2”
FXS Port #7: SIP UserID and Authenticate ID left blank, Hunting Group set to “1”
FXS Port #8: SIP UserID and Authenticate ID left blank, Hunting Group set to “2”
…
FXS Port #24:SIP UserID and Authenticate ID left blank, Hunting Group set to “2”
A single call directed to the SIP account will NOT result in all ports ringing at the same time. They will ring in the hunting
group only. This feature is applicable to incoming calls only.
FXS Name: GXW will use CID name from FXS port initiating the outgoing call if the “Name” field is entered for that specific
port.
To Next Page
Loading...
