Ring
Tones
System
Ring
Cadence
Configuration option for all FXS ports ring cadence for all incoming calls.
(Syntax: c=on1/off1-on2/off2-on3/off3; […]) Default is set to c=2000/4000; (US standards)
Call
Progress
Tones
Using these settings, user can configure tone frequencies according to user preference. By default, the tones
are set to North American frequencies. Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds. ON is the period of ringing (ON time in ms) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF
ms and then repeat the pattern.
• “Dial tone”
• “Ring back tone”
• “Busy tone”
• “Reorder tone”
• “Confirmation tone”
• “Call-Waiting tone”
• “Prompt Dial tone”
• “Conference Party hangup tone”
Please refer the document below to determine your local call progress tones:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
FXO
Failover
Failover
to FXO
Gateway
Enable or disable the Failover FXO Gateway.
FXO
Gateway
IP
IP Address or URI of the FXO gateway.
With secret Key information
Allow users to configure whether the packet capture file
contains secret key information or
not. It is set to Yes by Default
Status
Start/stop Ethernet capture.
Warning: This feature can only be used for debugging
purposes, please delete all files after finishing debugging.
To Next Page
Loading...
