CONNECT YOUR GXW42XX GATEWAY
Connecting the GXW42XX gateway is easy. Before you begin, please verify the contents of the GXW42XX package.
Equipment Packaging
Unpack and check all accessories. Equipment includes:
one device unit
one RJ45 Ethernet cable
one 12V 5A universal power adapter (24V 6.25A for GXW4248)
mount
Connect the GXW42XX
Follow these four (4) steps to connect your GXW42XX gateway to the Internet and access the unit’s configuration pages.
1. Connect standard touch-tone analog phones to the GXW42XX’s RJ21 port with a RJ11 to R21 cable.
2. Insert anRJ45 Ethernet cable into the WAN port of GXW42XX and connect the other end to an uplink port (a router or a
modem, etc.)
3. Plug the power adapter into the GXW42XX gateway into a power outlet.
Follow the instructions from the topic “Configuring GXW 42XX with Web Browser” for initial configuration. The GUI pages will
guide you through the remaining steps to set-up your gateway.
GXW42xx V2 device uses a different firmware file from the GXW42xx V1 device. Please use the correct firmware file for V1 and
V2 devices. To distinguish GXW42xx V2 device from V1 device, please check the label on the back of the device.
(1) GXW42xx V2 has “V2” printed for model name. For example, “Model: GXW4216 V2”. If the model’s name doesn’t have V1 or
V2 printed, the device is GXW42xx V1.
(2) GXW42xx V2 has the device password printed on the label. GXW42xx V1 does not have it.
To Next Page
Loading...
