There are two types of hunting groups, Linear and Circular. Linear style will sort the call to the lowest-numbered available line,
this is also called “serial hunting”. Circular style will distribute the calls “round-robin”. If a call is assigned to line 1, the next call
goes to 2 and the next to 3. The succession throughout each of the lines continues even if one of the previous lines becomes
available. When the end of the hunt group is reached, the hunting starts over at the first line. Lines are skipped if they are still
busy on a previous call. These two hunting styles can be configured from the Profile X page.
Inter-Port Calling
In some cases, a user may want to make phone calls between the phones connected to multiple ports of the same gateway
when it is used as a standalone unit, without the use of a SIP server. This feature will also be applicable when the gateway is
used with Hunting Groups and is registered to SIP server only with one master number. In such cases, users still will be able to
make inter-port calls by using the IVR feature.
For example, on the GXW42XX inter-port calling is achieved by dialing *** and 7 plus two extra digits corresponding to the
port number. For example, the user connected to port 1 can be reached by dialing *** and 701; the user connected to port 24
can be reached by dialing *** 724.
Sending and Receiving Fax
GXW42XX supports fax in two modes: 1) T.38 (Fax over IP) and 2) Fax Pass through. T.38 is the preferred method because it is
more reliable and works well in most network conditions. If the service provider supports T.38, please use this method by
selecting T.38 as fax mode (default). If the service provider does not support T.38, pass-through mode may be used. If you
have problems with sending or receiving Fax, toggle the Fax Tone Detection Mode setting.
CALL FEATURES
GXW42XX supports the traditional telephony features available in a PBX as well as additional advanced telephony features.
Key Call Features
*02
Forcing a Codec (per call): *027110 (PCMU), *027111 (PCMA), *02723 (G723), *02729 (G729), *0272616 (G726-
r16), *0272624 (G724-r24), *0272632 (G726-r32), *0272640 (G726-r40), *027201 (iLBC)
*03 Disable LEC (pe call) Dial “*03” +” number”. No dial tone is played in the middle.
*16 Enable SRTP
*17 Disable SRTP
*30 Block CallerID (for all-config change)
*31 Send CallerID (for all-config change)
*67 Block CallerID (per call)
*82 Send CallerID (per call)
*47
Direct IP Calling. Dial “*47” + “IP address”. No dial tone will be played in the middle. Detail see Direct IP Calling
section on page 12.
*50 Disable Call Waiting (for all-config change)
*51 Enable Call Waiting (for all-config change)
To Next Page
Loading...
