Static IP Settings
IP Address Configures static IP Address
Subnet Mask Configures Subnet Mask
Gateway Configures Gateway address.
DNS Server 1 Configures primary DNS Server.
DNS Server 2 Configures secondary DNS Server.
Network settings for Management Interface
Enable management interface
An interface for HTTP/HTTPS/SSH, the management interface will be a VLAN
interface if management VLAN is configured and different to service VLAN,
otherwise, a sub interface will be created on service interface.
Sub interface can only be configured with a static IP address without the default
gateway if both management and service interface are using the same VLAN the
management interface will automatically use the gateway of the service interface.
Management access
Allows to choose which interface can be reached for HTTP/HTTPS/SSH
● Both on service and management interfaces
● Management interface only
Enable SNMP Through Management
Interface
Whether to route the SNMP packets through the management interface
Enable Syslog Through Management
Interface
Whether to route the Syslog packets through the management interface. (GXW42xx
V2 only)
IP Address Mode for Management
Interface
Allow to choose how the IP address will be obtained on the gateway for
management interface.
● DHCP
● Static IP (defaul)
Static IP Settings (Management Interface)
IP Address
Enter the IP address when static IP is used for the management interface.
The default setting is 192.168.10.10
Subnet Mask
Enter the Subnet Mask when static IP is used for the management interface..
The default setting is 255.255.255.0
Gateway
Enter the Gateway when static IP is used for the management interface.
The default setting is 192.168.10.1
DNS Server 1
Enter DNS Server 1 when static IP is usedor the management interface.
The default setting is 192.168.10.1
DNS Server 2
Enter DNS Server 2 when static IP is usedor the management interface.
The default setting is 192.168.10.1
LLDP
To Next Page
Loading...
