Grandstream Networks GHP6 Series - Hunting Group Type; Hunting Group Ring Timeout; Call Features Settings; Enable Call Features

Replace Beginning ‘+’ with 00 in Caller ID
Allows the device to detect if the FROM header including the “+” sign at the
beginning of a number:If set toYes,the “+” sign will be replaced by “00” before
delivering the caller ID to the attached analog phone.If set toNo(Default), the “+”
sign will not be displayed.
Hunting Group Type
Linear and Circular. Linear style will sort the call to the lowest-numbered available
line, this is also called “serial hunting”. Circular style will distribute the calls “round-
robin”. If a call is assigned to line 1, the next call goes to 2 and the next to 3. The
succession throughout each of the lines continues even if one of the previous lines
becomes available. When the end of the hunt group is reached, the hunting starts
over at the first line. Lines are skipped if they are still busy on a previous call. These
two hunting styles can be configured from the Profile X page.
Hunting Group Ring Timeout
Default is20 seconds. If call is not answered within this designated time period, the
call will be forwarded to the next member of a Hunt Group.
Call Features Settings
Enable Call Features
When enabled, Do not Disturb, Call Forward and other call features can be used via
the local feature code on the phone. Otherwise, the ITSP feature code will be used.
Enable All will override all individual features enable setting.
Note: When call features on GXW42xx are enabled (UCF, DND…), if picking up the
handset, GXW42xx will play stutter tone to indicate that a call feature is active then
the dial tone will be played after that.
Reset Call Features Allows users to reset call features via Web UI. Default isNo.
SRTP Feature Default isYes, and star code is Enable-16, Disable-17.
SRTP per call Feature Default isYes, and star code is Enable-18, Disable-19.
CID Feature Default isYes, and star code is Enable-31, Disable-30.
CID per call Feature Default isYes, and star code is Enable-82, Disable-67.
Direct IP calling Feature Default isYes, and active star code is47.
CW Feature Default isYes, and star code is Enable-51, Disable-50.
CW per call Feature Default isYes, and star code is Enable-71, Disable-70.
Call return Feature Default isYes, and active star code is69.
Unconditional forward Feature Default isYes, and star code is Enable-72, Disable-73.
Busy forward Feature Default isYes, and star code is Enable-90, Disable-91.
Delayed forward Feature Default isYes, and star code is Enable-92, Disable-93.
Paging Feature Default isYes, and active star code is74.
DND Feature Default isYes, and star code is Enable-78, Disable-79.
Blind Transfer Feature Default isYes, and active star code is87.
Disable LEC per call Feature Default isYes, and active star code is03.
3WC Feature
Disable Bellcore-style 3-Way Conferencedefault isNo. If set toYes, flash on 2ndline
will not bring 2ndline in to the conference with 1stline. Instead, flash will switch
between lines.
Star Code 3WC Featuredefault isYes.
3WCactive star code is23.
Provision start Feature Default isYes, and active star code is99.
Play registration id Feature Default isYes, and active star code is98.
Play port number Enable the port playing feature
Enable playing port number
This feature allows users to use the star code to check the port number the analog
phone is connected