▪ Preferred IPv4 DNS
Enter the Primary IPv4 DNS.
▪ Alternate IPv4 DNS
Enter the Alternate IPv4 DNS.
• Frequency
Set the GWN76xx’s frequency, it can be either 2.4GHz, 5GHz or Dual-band.
• Enable Band Steering
When Frequency is set to Dual-Band, users can check this option to enable
Band Steering on the Access Point.
This will help redirecting clients to a radio band accordingly for efficient use
and to benefit from the maximum throughput supported by the client.
• Mode
Choose the mode for the frequency band, 802.11n/g/b for 2.4Ghz and
802.11ac for 5Ghz.
• Channel Width
Choose the Channel Width, note that wide channel will give better
speed/throughput, and narrow channel will have less interference. 20Mhz is
suggested in very high density environment.
• 40MHz Channel Location
Configure the 40MHz channel location when using 20MHz/40MHz in Channel
Width, users can set it to be “Secondary Below Primary”, “Primary Below
Secondary” or “Auto”.
• Channel
Select “Auto” or a specific channel. Default is “Auto”. Note that the proposed
channels depend on Country Settings under System
Settings–>Maintenance.
• Enable Short Guard Interval
Check to activate this option to increase throughput.
• Active Spatial Streams
Choose active spatial stream. Available options: “Auto”, “1 stream”, “2
streams” and “3 streams” (For GWN7610).
• Radio Power
Set the Radio Power depending on desired cell size to be broadcasted, three
options are available: “Low”, “Medium” or “High”. Default is “High”.
To Next Page
Loading...
Need help?
General
